MS 7518 VER 1.0 DRIVER

The module will only fit in the right orientation. You can insert the expansion cards to meet your needs. Hook one end of the clip to hook first, and then press down the other end of the clip to fasten the cooling s et on the top of the retention mechanism. The gold arrow should point as shown in the picture. Danger of explosion if battery is incorrec tly replac ed. Power supply of watts and above is highly recommended for system stability.

Uploader: Molabar
Date Added: 23 May 2004
File Size: 42.38 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 85504
Price: Free* [*Free Regsitration Required]

You can insert the expansion cards to meet your needs.

Revision History Revision V1. Users can install either single- or double-sided modules to meet their own needs. The Ultra ATA interface boosts data transfer rates between mms computer and the hard drive up 77518 megabytes MB per second. However, memory modules of the same type and density are required while using dual-channel DDR, or instability may happen.

Before inserting the power supply connector, always make sure that all components are installed properly to ensure that no damage will be caused. All cautions and warnings on the equipment should be noted. Never pour any liquid into the opening that could damage or cause electrical shock.

See Also  DG41 INTEL MOTHERBOARD DRIVER DOWNLOAD

MSI MS Instruction manual |

Position the cooling set onto the retention mechanism. Fix the retention mechanism and the backplate with two screws. X Micro ATX mainboard. Lower the CPU down onto the socket.

Alternatively, please try the following help resources for further guidance. The plastic clip at each side of the DIMM slot will automatically close. The module will only fit in the right orientation. The openings on the enclosure are for air convection hence protects the equipment from overheating.

Hardware Setup Hardware Setup This chapter tells you how to install the CPU, memory modules, and expansion cards, as well as how to setup the jumpers on the mainboard. Microsoft is a registered trademark of Microsoft Corporation. Replace only with the same or equivalent type recommended by the manufacturer. For the latest information about CPU, please visit http: ATX 12V power connection should be greater than 18A.

Lay this equipment on a reliable flat surface before setting it up. However, please make sure your components are able to tolerate such abnormal setting, while doing overclocking. To clear CMOS you should: Open Lever Sliding Plate 90 degree 2.

As the end user cannot boot without SP4, a combination installation CD must be created before attempting to install the operating system onto the bootable RAID volume. Any attempt to operate beyond product specifications is not recommended. Turn over the mainboard again, and plac e the mainboard on the f lat surface.

See Also  CANON IR3100C PRINTER DRIVER

MSI K7N2GM-L, Socket A, AMD (MS-6777) Motherboard

If you do not have the heat sink and cooling fan, contact your dealer to purchase and install them before turning on the computer. W hen adding or removing expansion cards, make sure that you unplug the power supply first. Operation is subject to the following two conditions: Look for the gold arrow on the CPU. Meanwhile, read the documentation for the expansion card to make any necessary hardware or software settings for the expansion card, such as jumpers, switches or BIOS configuration.

Locate the two screw holes of the mainboard. Overclocking This motherboard is designed to support overclocking. While disconnecting the Safety Hook from the fixed bolt, it is necessary to keep an eye on your fingers, because once the Safety Hook is disconnected from the fixed bolt, the fixed lever will spring back instantly.

Correc t CP U placement 4.